Does any one know the correct size (and where to get them) for the screw that holds down the base plate in a Sprite distributor.
Seems that a 6/32 is too small and a 8/32is too big
Distributor Plate screw size
1 post
• Page 1 of 1
Distributor Plate screw size
by Joe Schlosser » Tue Jun 03, 2014 11:58 am
Joe
NESCCA FP 48 (Retired)
1960 Bugeye
NESCCA FP 48 (Retired)
1960 Bugeye
- Joe Schlosser
- 948cc
- Posts: 123
- Joined: Sun Nov 28, 2004 2:02 pm
- Location: New York
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest