Wire Loom routing

Have a Lucas question?

Wire Loom routing

Postby KenR » Thu Jul 31, 2008 2:35 pm

Does anyone have some pics of the routing for the wire loom between the dash and the trunk area. How is it routed, are there clips, etc. The clips on my Bugeye body were all removed by DPO. thanks,
-Ken
KenR
948cc
 
Posts: 96
Joined: Wed Nov 07, 2007 5:30 pm

Re: Wire Loom routing

Postby Bugzy59 » Thu Jul 31, 2008 2:55 pm

Hey Ken:
I will take a peek at mine this PM. Generally, they jump up over the right rear wheel. There are some thin gauge tabs which bend over the harness. It is in between the inner shell and right fender in front of the wheel. It then jumps out and runs just above the floorboard below the door. I think I have two screw clips. These are covered by the vinyl cover panels. I have to look at the routing just below the dash. My recollection is that there is a single screw clip about two inches inboard from the door seal.
User avatar
Bugzy59
1275cc
 
Posts: 527
Joined: Fri Apr 08, 2005 7:44 pm
Location: Maryland


Return to Electrical

Who is online

Users browsing this forum: No registered users and 1 guest

cron