wire wheel axle conversion 1/4 elipticle

Got a pumpkin problem? Want to change gear ratios? This is where to go.

wire wheel axle conversion 1/4 elipticle

Postby Bob C » Sun Dec 25, 2005 12:34 am

as the wire wheel axle shaft is shorter,I have been told that one could pull/press the shaft out of the splined hub to make the whole thing longer. Apparently,there might be enough meat left in the splined hub to not conpromise the strength? The answer is ,of course, to get a true 1/4 wire wheel axle assembly which I understand is rather rare. If I found one,how would I identify it? Sliding the shorter shaft into the assembly will not allow full engagement into the diff. Is this really a problem with a 1275? Bob C
Bob C
Pit Crew
Posts: 4
Joined: Sun Dec 25, 2005 12:06 am
Location: Kansas

Postby spritenut » Tue Dec 27, 2005 11:38 pm

I have converted a couple of Sprites to wire wheels from solid wheels.
I know the axles are different but I never had a problem with the shorter wire axles in the disc wheel axle housing.
And I drive em hard :lol:
So if it's not on a race track, just use what you have.
And if it's on a race track, get rid of the wires 8)
Frank Clarici
Toms River, NJ
The BETTER not BIGGER Healeys
Posts: 610
Joined: Mon Jun 14, 2004 9:41 pm
Location: Toms River, NJ

Return to Differential / Rear Axle

Who is online

Users browsing this forum: No registered users and 1 guest